Motorcycle Storehouse

Select your bike

BIKE SELECTOR

20 of 78 search results

Sort on:

Sort on:

Dual spindle; Used to machine cases for high lift cams

George's Garage, cam relief tool

#979419

Stock:Yes

Single spindle; Used to machine cases for high lift cams

George's Garage, TC cam relief tool

#979418

Stock:Yes

Used to correctly align ignition switch housing for installation.

George's Garage, ignition switch housing tool

#979475

Stock:Yes

Removes & installs right side pinion shaft crankcase bearing without damage

George's Garage, pinion crankshaft bearing tool

#979470

Stock:Yes

Installs cam shaft needle bearing.
Note: 979461 driver handle required for installation and must be purchased separately

George's Garage, cam bearing installer tool

#979467

Stock:Yes

Used to remove the electrical connector without damage to the ignition switch.

George's Garage, ignition switch connector tool

#979476

Stock:Yes

Used to push down the 17945-36B pushrod spring cup and easily install the pushrod retainers without damage to the pushrod clip/spring cover.

George's Garage, pushrod clip installer

#979427

Stock:Yes

For use with 979429 clutch spring compressor tool. Makes 979429 compatible with XL Sportster and Buell models.

George's Garage, clutch spring adapter nut

#979430

Stock:Yes

Used to lock motor sprocket & clutch basket for removal and installation of the engine and clutch hub nuts.

George's Garage, primary drive lock tool

#979432

Stock:Yes

Used to release clutch spring for removal and installation of retaining ring.

Note: Order 979430 adapter separately for use on XL Sportster models.

George's Garage, clutch spring compressor

#979429

Stock:Yes

Delrin; Holds both camshafts in an upright position while lowering the cam support

George's Garage, camshaft assembly tool

#979414

Stock:Yes

Adapts 979418 and / or 979419 (99-06) tool so it is compatible with (06-17) hydraulic chain tensioners

George's Garage, cam relief pilot

#979420

Stock:Yes

Removes and installs the wristpin in a controllable process with slide hammer action. No need to use force.

George's Garage, wristpin tool

#979400

Stock:Yes

Adapter only for use on fine-spline sprocket shafts
Note: Use with 979426 sprocket shaft bearing installer tool

George's Garage, sprocket shaft adapter kit

#979472

Stock:Yes

Used to remove transmission doors, with gears and shaft attached, without causing damage to door bearings.
Note: Will not fit 2006-up OEM 6-speed Cruise Drive transmissions.

George's Garage, trapdoor puller tool

#979435

Stock:Yes

Used to install and remove new wristpin bushings without removing connecting rods from the crankcase. Removes and installs both bushings in less than 5 minutes.

George's Garage, wristpin bushing driver tool

#979409

Stock:Yes

For 3.750 - 3.938 more cylinders with STD bolt pattern; Plates simulate stress conditions when boring and honing, which prevents distortion of cylinders walls once cylinders are installed

George's Garage, cylinder torque plates

#979468

Stock:Yes

Used to align engine, transmission and swingarm with each other to the correct position.

George's Garage, FLT power train alignment tool

#979459

Stock:Yes

Used to remove & install transmission bearings; Will also remove transm. door without removing the gear set or transm. assembly;
Note: Door bearings must be replaced if using this tool to remove the door only.

George's Garage, transmission door bearing tool

#979445

Stock:Yes

For 41mm forks; Used to install fork seals & bushings in fork sliders; Two-piece split design

George's Garage, fork seal & bushing install tool

#979454

Stock:Yes