16 of 16 search results

SORT ON:

Used to remove the electrical connector without damage to the ignition switch.
MCS
New

MCS, ignition switch remover tool

#987918

Stock:Yes

Pulls and installs alternator rotor as used on M8 motors. Overcomes the strong pull of the high performance rare earth magnets that are used with ease. Prevents damage by using inappropriate tools as hammers or pry bars.
Jims

JIMS, alternator rotor tool

#559406

Stock:Yes

Used to correctly align ignition switch housing for installation.
George's Garage

George's Garage, ignition switch housing tool

#979475

Stock:Yes

Used to install & remove 12mm threaded 4-wire heated front & rear oxygen sensors. Can be used with a torque wrench for a factory spec installation.
Jims

JIMS, O2 sensor wrench tool

#961579

Stock:Yes

Used to remove the electrical connector without damage to the ignition switch.
George's Garage

George's Garage, ignition switch connector tool

#979476

Stock:Yes

Used to align the ignition switch housing when retaining screws are torqued. Correct alignment for the ignition switch knob is required to help prevent premature failure.
Jims

JIMS, ignition switch housing tool

#961418

Stock:Yes

Used to pull the alternator rotor from the sprocket shaft, without issues associated with strong magnets. Pulls simple and direct without damage to any components. Designed for use on most Touring models with 45 Amp high output rotors that have 2-hole style threaded 'pull holes'.
MCS

MCS, 45A alternator rotor puller tool

#925554

Stock:Yes

Used to remove and install the ignition switch/fork lock. This tool locates on the ignition switch face nut that holds the switch in place on the frame, letting you remove or install this switch correctly. Tool has a 3/8" drive access hole.
Jims

JIMS, Dyna ignition switch & fork lock tool

#961594

Stock:Yes

Used to remove and install both the fork lock/ignition switch combo with ease. Installs on the ignition switch. Comes with 3/8" drive.
MCS

MCS, Dyna ignition switch & fork lock tool

#925525

Stock:Yes

Pulls 29981-95 (38A) & 29999-97A/B (45A) style, and similar, rotors with a threaded pull action from the sprocket shaft. Especially helpful with the strong magnetic hold on 45 Amp charging systems.
Jims

JIMS, alternator rotor puller tool

#978393

Stock:Yes

Used for easy removal of the alternator rotor from the strong magnetic hold of 45 Amp charging systems. Will fit most rotors with a two hole system. Simply insert, pinch and pull tool to remove rotor.
Evolution Industries

Evolution Industries, alternator rotor puller

#552105

Stock:Yes

Used to lock the advance unit in the full advanced position when static timing points type ignitions.
MCS

MCS, ignition points timing tool

#925571

Stock:Yes

Used to align the ignition switch housing when retaining screws are torqued. Correct alignment for the ignition switch knob is required to help prevent premature failure.
Jims

JIMS, ignition switch alignment tool

#978632

Stock:Yes

Used to remove the electrical connector without damage to the ignition switch.
Jims

JIMS, ignition switch connector remover tool

#961419

Stock:Yes

Used to correctly align ignition switch housing for installation.
MCS

MCS, ignition switch housing alignment tool

#920948

Stock:Yes

With torque grip socket. Used to remove & install 5/16" and 10mm side terminals and hold down fasteners. Extra long, 9 3/4" (24.8cm), for easy access to recessed terminals. 10mm & 5/16".
Lang Tools

Lang Tools battery long terminal wrench

#514579

Stock:No